ring size

How To Measure

Based On Existing Ring

01 Choose an existing ring that fits the desired finger and place the ring on a flat surface

02 Measure the inner diameter of the ring in mm

03 If the measurement falls between 2 sizes, choose the larger size

Paper Strip Method

01 Cut a strip of paper 1cm wide and mark the start point by using a pen

02 Wrap around the base of your finger. It has to fit snug, but not too tight.

03 Mark the endpoint where it overlaps on the start point forming a circle (if your knuckle are much larger than the base of your finger)

04 Lay the paper flat and measure from start to endpoint. To determine your ring size, please refer to the ring size conversion chart.

Measuring Tips

01 Measure 3 to 4 times for more accuracy.

02 Take the larger size if you are in-between sizes.

03 Measure your ring size at the end of the day when your fingers are warm.

04 If the knuckle is larger than the base of the finger, take two separate measurements and pick a size in between.

05 Take note that fingers on your dominant hand are usually larger.